// mag mount for lid
// used double sided tape to stick a M6 washer (cut in half) to the top of the Z
// and then sliced some duct tape into a thin strip and wrapped it around, so
// the half washer was stuck both sides.

// then broke a HD magnet into four parts, not particularly evenly.
// With the Zs + half washers hot glued to the hull lip, the magnets
// were placed on the washers and left to find a good location.

// then blobbed hot glue onto all for magnet fragments, and quickly
// put the hull lid onto it, holding it down to make the lid (which was 1mm banana
// shaped) straight.

// When cold, then turned the lid over and hot glued the magnet fragments
// some more, half at a time, so that the existing hot glue didnt melt.


magheight=2;   // thinkness of hard disk magnet
steelheight=1.6;   // thickness of steel - these two aren't used, just need to set uplength to account for these two and varish and tollerances

thickness=3;  // thickness of Z shape

zwidth=20;    // how wide is the Z shape
hulldepth=10;  // how far the Z shape goes under the hull
uplength=10.0-magheight-steelheight;   // length of the middle of the Z shape, needs to account for thickness of magenet, thickness of steel, amount of varish. 

vislength=10;  // how much is visable, ie, the tab that the steel sits on

cube([hulldepth+thickness,zwidth,thickness]);

translate([hulldepth,0,0])
   cube([thickness,zwidth,thickness+uplength]);

translate([hulldepth,0,uplength])
   cube([vislength,zwidth,thickness]);